FastCap Kaizen Foam Sheet for Tool Organizers and Storage - Perfect for Professional Contractors and Technicians - 57mm Thickness, 2' x 4' Sheet Size, Black & Red

Great deal on foam. Worked out great. I used a silver sharpie to mark out my tools and an exacto to cut out the foam. Be sure to take your time

Like most other reviews have said, it isn't that easy to peel apart but here was my solution. I used a trim router with a 1/2" straight cut bit, set the bits depth to the exact depth of the foams layer i wanted to remove, and cut out the pattern I traced on it. Worked like a charm, but produces alot of mess so have a shop vac ready when you do it and hold it at the base to collect it all as you go.

PROs: Easy to cut, sturdy enough to create perfect fit, protects your tools, toys, equipment CONs: Glue holding the layers together is so strong it doesn't release & causes the foam to tear instead It was pretty easy to cut using a sharp hobby knife, and foam is a high quality. I highly recommend it, but deduct a star for the layers not coming apart but rather tearing which causes gouges and uneven surface.

This is perfect for custom toolbox/chest storage and organization. Can be cut with a box cutter/knife or laser cutter! Shipped well too.

Great product. Im not sure why people complained about being difficult to pick and not square. My sheet was square so I only had to make 2 cuts for my single drawer. I also had no issues picking it at all. You just have to make a nice straight cut with a SHARP blade and then peel it up as one solid piece. Don't try and pull from the top. Get your finger under there and peel it up like you are peeling up a stuck piece of tape and keep doing that. It won't be 100% flat but who cares, it's to support tools and what not. You can get fancy with a hot knife, soldering iron or other tool. TIP: Take some painters tape and put that down first, then you can draw out your tools. 2nd Tip: Take the painters tape and it apply it to your jeans/shirt first a few times. I found the painters tape DID pull up some of the black material if pushed down too hard but it worked GREAT to lay out my tools.

Excellent product and a good deal based on usage.

I've read several reviews about the layers not pulling out in and even layer. My experience was the same when using a knife to make the cuts. I discovered that using a Dremel with a multi purpose cutting tool or a drywall cutting tool the foam cuts very accurately. With some care you can control the depth to a very fine degree and for some reason it pulls out very uniformily and leaves a very professional surface at the bottom of the cut. The knife works but the Dremel works perfectly. The Dremel turns this from a good product to a great product.

Used inside a custom truck bed tool box drawer for my power tools. Nice and thick, cuts easy with a razor blade. Just trace and cut

My toolbox looks awesome, spent a couple hours cutting in the tool outlines, well worth the effort. Foam is layered in 1/8” layers, so easy to get a perfect fit.

good & solid

Perfect for lining a tool case with heavy tools. Used it to replace "pick and pluck foam", which was not up to the task.

Easy to cut and peel. Makes your custom tool organization easy.

The material is really easy to cut and makes much sense that you can peel off the layers to create the depth you need. However, the layers between them are glued together and it is not hard to create a nice flat surface. Still, this foam made my life a lot easier