Wera 05118007001 Kraftform Micro 2035 Slotted Electronics Precision Screwdriver, 2mm Head, 100mm Blade Length, Black

Needed a 2mm screwdriver for electrical work in the controls field working in PLCs. This on is perfect. Well made screwdriver and a true non flared 2mm

Bought to adjust burners on new cookstove. It worked well for that.

We recently purchased a Z-Line 36” Range and the burners seemed too high. The lowest setting didn’t give a nice low flame. I initially thought we made a bad decision but after some research realized that burners are adjustable. The best tool I had was a screw driver from an eyeglass repair kit which fit in the hole but wasn’t long enough to reach the notch inside to make the adjustment. I measured the width and noticed it was 2mm wide. I looked around and came across several screw drivers that initially appeared to be the right size based on the description but as I dug deeper I realized the descriptions were not very good and sometimes misleading. Note: the measurement of the shaft is the key, not the head. There were several where the shaft was 3mm and head was 2mm… the focus of the descriptions were “2mm”. I got comfortable that this screw driver was 2mm for the entire shaft and purchased it. At first look I thought it wasn’t going to fit but when I tried it, it fit perfectly as you can see. It had to go in about 2 inches. I can’t speak to durability as I’ve only used it to adjust my burners. It seems solid enough but I wouldn’t expect any tool of this width to not bend or chip under harsh use.

Found item. It is intact and just fine

2mm / 100 If you have a z line 30 inch cooktop 4 burner This is the one that will fit Into the gas adjustment knob to set your flame height. Dont spend $32 from z line to buy their specific tool.

Excellent, well-made precision product that did exactly what I needed it to do, which was to turn the burner lower on my stove. The stove flame was way too high. This worked great and fixed the problem in a few seconds. I'm sure it will come in handy for other uses too (eyeglasses, computer, watches, etc.). Glad I got it.

Great screwdriver. I use the 3.5mm on my airbrush all the time.

I have tried multiple sizes to adjust the flame on my Zline 36” range. The 1.8mm did the trick!! 2mm was recommend in the manual, but it was too wide to fit. This tool made it super easy and sooo much less expensive than hiring someone to come adjust the range for me!

Just one word Brilliant

Es bonito y se ve de muy buena calidad. La pena es que llegó tarde y ya no hacía falta pero lo recomiendo

Destornillador fantástico, robusto y fiable. Utilizo esta marca de desatornilladores desde hace tiempo y nunca he tenido problemas, son un poco caros pero merece la pena cada euro invertido ya que te duraran prácticamente toda la vida.

ok

just excellent