Mitutoyo "2416S" Dial Indicator, 4-48 UNF Thread, 0.375" Stem Dia., lug Back," White Dial, 0-100 Reading, 2.244" Dial Dia., 0-1" Range, 0.001" Graduation, -0.002" Accuracy

As exspected you get what you pay for.I use this indicator every day.I'm a Machinist in the steam turbine and nuclear power industry.So my equiptment has to perform at the highest levels.It's not a starrett but for the money it gets the job done well.The action is smooth and repeats every time.You can spend alot of money on junk or cry once on the good stuff.I only buy starrett mitutoyo noga.I've learned over the 30 plus years of machining if you want good parts coming out you have to invest up front on good indication equiptment. Your cuts will only be as good as your setup.

Typical Mitutoyo quality at a fair price. Silky smooth operation. Last year I bought a cheap dial indicator set with magnetic base and extra spindles for a ridiculously low price and as expected, got what I paid for. The cheap magnetic base works ok, but the cheap dial indicator is very rough and jerky. All of the cheap accessories work with the new Mitutoyo. I paid more than double the cost of the cheap one for just the Mitutoyo indicator but it is well worth it. Two thumbs up!

Since starting my own shop I've at some point lost my old indicator setup I used in the dealerships truing motorcycle wheels. I'd assumed that my old one was a nice indicator as it wasn't all that cheap when purchased from our catalogs. I was hoping to find one "as good" and seem to have acquired one that was actually nicer. Perhaps much nicer.I'm no machinist so I can't speak for the quality in that specific of a setting, but this little indicator is as nice as any I've encountered in my career. I took a little leap and ordered it from the "Amazon Warehouse" for roughly $40, but it arrived with all of the paperwork and a properly functioning indicator.This unit may be nicer than you will actually need if you're truing wheels. That said, I'm not upset in the least with this purchase. If you're looking for an indicator for that purpose this one will more than suffice.

Best of breed indicator. Expect to use this for a long while.

Just bought this Mitutoyo drop dial indicator and I couldn't be happier with it. Its very well worth the money and its not built cheap like some " bargain" indicators that you'll find. I've already used it for indicating in lathe work, mill work and I.D.-O.D. grinding work as well. Very accurate. I would highly recommend this drop dial indicator to anyone.

This indicator seems to be built well. It has a good fit and finish as you would expect to find with Mitutoyo. In terms of repeatability and accuracy I did not have a chance to measure, though the indicator came with a spec sheet. Passing a 2 rev indication within 0.001" accuracy. The only problem I have with the indicator is the bezel ring, it is plastic. It zeros extremely smooth and has a good resistance to hold position. I have compared the indicator movement with a Starret 25-441J indicator(whose bezel ring is also plastic) and I feel that the Mitutoyo is smoother and feels better put together less run out on the stem bore, however the Starrett has better plunger sensitivity. That of course is my own opinion.

Still as good as always, been using them for 35 years

I bought this dial indicator based on the reviews to replace the very cheap dial indicator on my expensive table saw blade alignment fixture. I made the appropriate adjustments to my saw according to the readings on the dial indicator and all adjustments were accurate. The adjustments were verified with several different cuts made with the table saw and measured with a digital caliper. I was able to finally get my table saw blade and RIP fence aligned spot on. This dial indicator was definitely worth the money.