JKS MFG. JKS OGS159 Rear Adjustable Track Bar for Jeep JK

Nice jks quality . Heavy duty . Works like it should on my 3.5 inch lifted jeep

Strong and easy to install

This is this is a great beefy bar for your the back end of your jeep. I have a JK with a Dena 60 rear end and this gives me plenty of room for the pumpkin housing cover so I don’t hit anything.

Great quality product from AEV. I had to remove my rear trackbar relocation bracket (AEV) as the trackbar would not shorten enough to allow for the axle to be centered. Works perfectly in the stock axle side mount location, and ride quality is only slightly affected. No clearance issues with my Poison Spyder diff cover.

4 inch lift on 35’s, stock brackets, easy install with plenty of room leftover for adjustment, solid sturdy bar and budget friendly

I don't know why everyone is saying it is too long. I have a 2.5" lift on my JKU sport. This fit perfectly. It was just too short when screwed all the way in so it fit perfectly once I adjusted it out a few turns. If you have any less of a lift, there really is no need for a new track bar anyway, so this should fit your needs if you have at least a 2.5" lift. Install is a little tricky, but that's no fault of the product. Just the nature of this install. The passenger side brake line was in the way when trying to remove the old bar. Just remove the 10mm bolt holding it to the frame right inside the wheel above where the track bar mounts for easier access. I also recommend loosening the bolt attaching the track bar bracket to the frame on the passenger side first to make it easier to remove the old bar and put the new one in. Had trouble getting it in around the rear diff. Install the passenger side first with nut just hand threaded on. Then you can swing the other end around the diff and into place, adjusting the length as needed. Had to tap the driver side end into the bracket with a hammer as it was a very tight fit. Overall, product fits, works and looks great, and install isn't too bad. The worst part is removal of the old bar and lining everything up.

This thing is heavy duty and easy to adjust and install. Just be sure you have a big enough wrench to tighten down the jam nut. If lifted you should consider some type of relocation bracket to keep your geometry correct

Easy to install and required if you lift your Jeep or put larger tires on it. I went one size larger and the rear alignment went out by an inch. The stock track arm cannot be adjusted.

Great product,but had to cut 1 inch off. Was to long with a frame side drop bracket.

Survived too late had to order from another seller