HackHD 1080P Camera Circuit Board and Basic Starter Kit

Description

The HackHD uses one button operation. Whenever pin 3 is grounded, the button is activated. This can be connected to a push button, relay, motion controller, microcontroller (Arduino), or any other sensor that can ground it. If held down for a fraction of a second, the camera will boot up and start recording automatically in auto mode. It will not stop recording until the terminal is grounded again or the battery runs out in which case it will stop recording an turn off. This is the best method of saving the battery. If you have a external power source or a high capacity battery, you can use standby mode by grounding pin 3 for 3 seconds to turn it on in standby mode. The LED will go solid until you ground pin 3 for a fraction of a second and it will immediately start recording until grounded again. To turn it off just ground it for 3 seconds.