YoungRC 30A ESC Brushed Electric Speed Controller, w/Brake | For DIY Mini RC Car or Boat Tank w/Brake

As the other reviewers have mentioned. I also have no signal to motor on both ESC's. *Update 7/7/2020 I was sent two replacement ESC's. the replacements work fine.

Awesome product and vendor. At first I was not able to get the reverse to work. I contacted the seller and and they sent me a video. It turns out that you need to connect the ESC to the Aileron / Elevator Stick of your radio control for it to work. I was originally connecting it to the Throttle stick which would only control the speed in one single direction. I bought 4 ESC and all of them work very well. Here is what I'm using: a brushed DC motor type 380 (Jameco Part number 232022), Radiolink AT9s Pro + R9DS, and a OVONIC 3s Lipo Battery 50C 5000mAh 11.1V. I had to buy a cable / connector kit to make cables to connect the ESC to the battery (JST to XT60 connector) and to the motors (JST to JST connector). I hope this review helps someone.

Bought 2 of these to change over a couple xmods and neither of the motor leads work. Turns on and steering works but motor won't run.

Great esc ,best if used on smaller scale rcs

These are small enough to put in a vehicle 1:24 and smaller. So far I have not had any issues. Very easy hookup. If you uh the Male end of the battery into the female end of this esc you can't go wrong.

Very small and powerful

Product does work, however not great for my application. I used it for a winch controller on my SCX10 ii. It does not seem to run the winch at full speed/power and was a little difficult to get to work with no instructions. Here is what I found: The esc will not take a fully charged 2s lipo battery. Input voltage is no higher than 8v and fully charged 2s is 8.4v. It will blink 1 led quickly if over voltage detected. The esc will blink 2 led quickly if no signal from reciever is detected. Once connected correctly and correct voltage supplied the esc comes on and goes through some kind of calibration procedure. I couldn't figure out the details but i had to go forward and reverse with throttle, left and right with steering, and the run Aux channel both ways. After that and a bunch of flashes from the leds it was working. Like I said, got it to work. But it underperformed and I will be getting a real winch controller as I know they work better than this does and they are less hassle to setup.

Nice fit for the Kyoshe nsr500 rc motorcycle

they have a drag brake programed in, just keep that in mind, they are meant for a fast car not a crawler, nothing wrong with em, just not what i was looking for