Cold Air Intake Kit & Blue Filter Combo Compatible for 2002-2006 Altima 2.5L

Went in relatively easy! Was able to bolt it up snug tight!

5 out of five stars for me on this one. It was the right fitment and it did go smooth as they say it does. As far as the performance of my car afterwards is 10x better, the sound is my favorite part and I like how my RPMs climb hell of a lot faster than before. If you're thinking about getting this for your car I definitely give it my stamp of approval. And the looks of it are even just as cool you can see it walking by it because it goes far into the wheel well. So sick.

Great product so far, hear and feel the difference. i had to pick up a couple sleeves for 20. to get it to fit. well worth not paying the 300. for k and N

Installation instructions were a very poor photocopy which basically read, "take out the old stuff, put in the new stuff." The instructions were not much help. The connector sleeves were not the correct sizes so I had to go to Napa and purchase the correct one for an addition $10. The intake manifold is 2 1/2 which connects to the 2 1/2 portion of this product. All of the sleeves provided were 3 to 2 1/2 reducer sleeves. So with poor instructions and incorrect pieces, rating is 3 stars.Once installed, the product performs well. At the cheap cost compared to other intakes, its worth the extra hassle for a short trip to Napa if your kit has the wrong parts.

Works as expected good outcome but need to make better fittings

The easy way to get your cold air intake inside the wheel well. Jack up drivers side front, remove wheel, take a screw driver and carefully pry the plastic clips holding the cover on the inside of the wheel well you only need to remove the front portion just enough to get your hand and the air filter up inside the fender. Its a little tough to tighten the band on the air filter to the pipe. But its much easier than the manufacturer telling to remove bumper to install the intake.

Not a bad cheapie. The mounting bracket broke off about a month in had to reweld it. sounds alot meaner, not really sure about any gains. morely its for looks and sound. It goes down the front fender and sits right above the drivers side fog light. Make sure you have your splash guards!